Easy Ways to Fix Your Computer Motherboard



The motherboard or mainboard is the board / main board where the main components such as microprocessors and memory (RAM, ROM, BIOS) chip along with other controllers.
There is also SLOT Expansion is the place to install additional cards that serve to enhance the facilities and capabilities needed.

Microprossor mounted on the socket / slot that conforms to the shape and size of the microprocessor, such as socket 370, 470, LGA 775, socket A 462 (AMD), the socket slot I (Pentium 2 and 3).

Mainboard In CPU Units

On the motherboard, microprocessor communicates with other components via a bus or data path. This bus has evolved from the bus 66, 100, 133, 200, 266, 333, 400, 500, 800 MHz. This development work to compensate for the faster microprocessor. Slot ekspansipun experiencing growth. Table diagrams have been included on the motherboard usually when you buy a CPU / Mainboard.

The total dead
Check the power supply: In the state of the power cable from the power supply off, disconnect the cable socket mounted on the Mainboard Atx1. Once released, attach the power cord back in, connect / shortkan green wire with black cable, check whether the power supply fan spinning? If the spin is a good power supply. Unplug the cable connections were Atx1 and reattach cables to the motherboard. Check the Clear CMOS Jumper, whether in position or Free Clear, usually when a new motherboard, the position of the CMOS jumper on the Clear position. Check the IC chipset plugged in and on the Switch On, whether or not excessive heat, over-heat means the chipset is already damaged. For part of CMOS ICs to date not sold freely.

Also check whether the switch on its functioning.
Unloading the Motherboard carefully, you try to wear clean thinners, if you can not use thinner bottles are in cans. After you dry clean. Replace the regulator IC which is located around the ATX power socket on the motherboard. Replace ElCo that seated 1000 s / d 3300 uf / 10 Volt located around the ATX power socket on the motherboard. Be careful to make sure the component loading plug the power cable not connected to the mains.

Flame But Not Shown
You try to watch and listen to whether there is sound or beep sound. If there is, there is usually damage to the processor, memory and VGA. Check Processor, you try to hold the coolant if the excess heat or cold? If excess heat means the processor fan is not working properly then you change, but if cold means the processor does not work broken alias.

Check the memory, usually when a faulty memory on the speakers audible beep 3 times. Are turned off, unplug the memory clean the pin using a pencil eraser to clean, then reinstall. If it means there's still broken one of his damaged IC. Check your VGA card, unplug the VGA card, in the dead / off you try to press, there are less chances you get or try to wash the feet / her pin. If the VGA card using the fan, clean the fan.

If it still does not appear try lest you check the monitor that is not a flame, to be sure that defective monitor or CPU, you try to press keys on the keyboard Numlock, whether Numlock lights its flame or not. If the flame is damage to the CPU.

Is the standard when fixing my computer, I always clean it from dust, whether it be the motherboard, memory, cdrom, floppy disks, etc., because it is so what else could affect the computer in a dirty / old are not cleaned. But you must be careful in the proceedings and do not rush.

Hang And Often Off / Restart (Reset) Himself
Check the Power Supply, try another power supply if it still restarts itself or hangs. If after replacement power supply turns normal / good, power supply means there is a problem. Change can be fixed if only because I myself not sure whether it is still able to function properly, because the power supply is a vital component.

Especially for the current price cheap power supply, I suggest changing it. Check if there is virus, anti-virus programs should always be installed and enable auto protect her. I used to use Norton Anti virus. You should frequently update your antivirus because if there is a new variant virus, anti-virus will detect once you eliminate the virus. At the moment there hangs and blue screen messages such as "vxd error at address ...", there is usually a problem in memory. Clean the memory is like a step above.

Try to reinstall Windows.
If it still hangs / restart itself let you check on the motherboard, you notice physical changes in particular components of Elco / capacitors, which are black round writing its capacity between 1000 uf/10Volt s / d 3300 uf/10 volts, usually seen, if the damage visible bloating / swelling and discharge or rust.
CMOS Checksum Failure (Battery Low)

Symptoms of damage & Solutions:
A message appears CMOS failure (damage to the CMOS battery, replace battery) Setting the date, time and other configuration in the BIOS change (After replacing the battery, re-do the settings in the BIOS).

1 comment: